Western-digital Network hard drive Manuel d'utilisateur télécharger pdf (Page 11)

CONNECTING THE NETCENTER – 7

NETCENTER

USER MANUAL

Connecting the NetCenter

1. Plug the AC adapter into an electrical outlet.

2. Connect the other end of the adapter into the DC power supply socket located on the

back of the unit.

3. Connect one end of an Ethernet cable into the Ethernet port located on the back of the

unit.

4. Connect the other end of the Ethernet cable directly into a router or network switch port.

Powering up the Drive

Note: Connection to power source (electrical outlet) is not immediately detected by the

power adapter. You must wait 5 seconds after the power cord is connected before pressing

the power button.

Press the power button to turn on the unit. The light encircling the power button will

illuminate and flash amber for up to two minutes (or longer if USB devices are attached)

before illuminating blue. Once the drive illuminates a steady blue, it is ready for use. Proceed

to follow the steps under “NetCenter Initial Setup” on page 10.

Color Indicates

Amber (steady)

Wait. NetCenter boots up.

Amber (flashing)

NetCenter problem detected. See “Troubleshooting” on page 50 or contact Technical Support at

support.wdc.com.

Blue (flashing) Drive Activity. NetCenter is being accessed.

Blue (steady)

NetCenter is ready for setup or use.

Important: Do not use the NetCenter after power-up until after the light encircling the

power button glows a steady blue.

NetCenter Ethernet port

AC adapter

Router port

Power supply socket

Ethernet cable

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 62 63

Pas de commentaire

Western-digital Network hard drive Manuel d'utilisateur Page 11