Western-digital Network hard drive Manuel d'utilisateur télécharger pdf (Page 13)

CONNECTING THE NETCENTER – 9

NETCENTER

USER MANUAL

Connecting a USB External Drive to the NetCenter

1. Connect and power on the USB external drive.

2. Connect one end of the USB cable to the external drive.

3. Connect the other end of the USB cable to an available USB port on the NetCenter.

4. Initial setup is complete. The next step will depend on the format of your external drive:

- FAT32 – the drive is automatically recognized as a shared folder. Proceed to the next sec-

tion, “NetCenter Initial Setup” on page 10.

- NTFS – allows read-only access. If you require read/write capability, reformat to FAT32

or claim the external drive as a permanent member of the NetCenter.

- Unformatted – format to FAT32 or claim the external drive as a permanent member of

the NetCenter.

To format a WD external drive to FAT32, visit the WD knowledge base at

support.wdc.com. To claim a drive, see “Claim a Drive” on page 48.

CAUTION: You must use the Safely Remove Disk function described in “Claim a Drive”

on page 48 to properly disconnect a USB external drive. Disconnecting an external USB

drive without using the Safely Remove Disk function may cause unstable NetCenter

behavior.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 62 63

Pas de commentaire

Western-digital Network hard drive Manuel d'utilisateur Page 13